Mircom TX3 Series Installation Manual download pdf (Page 36)

36 (53) TX3 Touch Screen Installation Manual Version 1.3

Touch Screen System and Setup

Speaker Connections. Audio speakers to Audio Mixer Board.

USB. Telephone Access Controller USB to PC Sub Compact Board USB

Power Supply Connectors. Power connectors from the MD-990 to the power

terminals

Power Connectors.

• Power connectors from power supply board to PC, controller and audio

mixer board.

• Power connectors from the power terminals to the Telephone Access

Controller and Power Supply Board.

• Power connectors from the Power Supply Board/Audio Mixer Board to

the PC Sub Compact Board.

Microphone. Microphone connection to the Audio Mixer Board

Speaker. Speaker connection to the Audio Mixer Board

On/Off Switches.

• The Telephone Access Controller power switch is ON by default.

• The Audio Mixer Board.Power Supply Board power switch is ON by

default.

3.10 Beginning Configuration

Ensure that the Telephone Access Controller ID is setup. This address is set by

the SW1 DIP switches on the Telephone Access Controller (Figure 14). The

individual switches are numbered 1 to 8 from left to right, and are marked as

either ON or OFF. The first five switches (1, 2, 3, 4 and 5) set the address ID.

Every TX3 System controller requires a unique ID. The unit ID settings do not

need to be in sequence but it recommended to assign IDs starting from 1, using

increments of one (e.g. 1, 2, 3, 4, etc.). Unit IDs must not be duplicated.

The Touch Screen controller is now ready for configuration. For a complete

description of the configuration and on how establish a connection to the Touch

Screen, see the following documentation:

• LT-995 Configuration and Administration Guide

• LT-973 TX3 Configurator Quick Start

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 53 54

No comments

Mircom TX3 Series Installation Manual Page 36