Mircom TX3 Series User's Guide Page 10
- Page / 61
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
10 (61) TX3-CX Card Access System Installation and Operation Manual Version 2.2
LT-980 Copyright 2015
Welcome
1.4 Installer Responsibilities
The installation and setup must be done by a qualified technician. The technician
is responsible for installing all of the system components, connecting all of the
input and output wiring for the appropriate door entry systems, and ensuring that
the wiring adheres to the requirements of the system for proper operation using
the configurator software.
1.4.1 PC Requirements
The following are the PC requirements:
• Dual core processor
• 1.8 GHz, 1 GB RAM
• Windows XP or later
• USB Connection
1.5 Network Setup
The Card Access System can consist of either stand-alone Card Access
Controllers or networked Card Access Controllers. Networked Card Access
Controllers can communicate over an RS-485 network, an ethernet TCP/IP
network, or a combination of an ethernet network with RS-485 subnetworks. All
Card Access Controllers can communicate over RS-485. To communicate over
an ethernet network you need at least one IP-enabled Card Access Controller
(called a Master Node).
The TX3 Configurator software can connect to any of these network
configurations. How you connect to the network (that is, through TCP/IP, USB,
a modem, or the COM port) determines what devices you can configure on the
network using the TX3 Configurator. The different network configurations are
explained in the rest of this section.
Figure 1 shows a basic Card Access System with one Card Access Controller and
two card readers. The maximum distance between the Card Access Controller
and the card readers is 500 feet.
Figure 1. Basic Card Access System
Card Reader A Card Reader B
Card Access Controller
- TX3 Series 1
- Copyright 2015 Mircom Inc 2
- All rights reserved 2
- Table of Contents 3
- List of Figures 6
- 1.2 Applications 8
- 1.3 Configurable Features 9
- 1.5 Network Setup 10
- LT-980 Copyright 2015 11
- 1.6 About This Manual 13
- 1.7 Contact Us 14
- 1.7.5 Technical Support 15
- 1.7.1 General Inquiries 15
- 1.7.2 Customer Service 15
- 1.7.3 Website 15
- 1.7.4 Email 15
- Configurable Features 17
- 2.1 Inputs 18
- 2.2 Correlation 19
- 2.3 Access Criteria 20
- 2.3.1 Lock / Unlock 21
- 2.3.2 High security 22
- 2.3.3 PC decision required 22
- 2.3.4 Facility code mode 22
- 2.3.5 Card + PIN 23
- 2.3.6 Anti-passback 23
- 2.3.7 Temporary card 23
- 2.3.8 Interlock 23
- 2.3.9 Access level 23
- 2.3.10 Controller options 24
- 2.3.11 Access point options 24
- 2.3.12 Card options 26
- 2.4 Timers 27
- 2.5 Schedules 28
- 2.6 Holidays 29
- 2.7 System Status 29
- • door held open alarm 30
- Installation and Setup 31
- 3.2.1 Optional Components 32
- 3.2.5 Installing the modem 33
- Installation and Setup 34
- SW1ONOFF 35
- Interface connection 35
- MD-921 IP Module 35
- Board location 35
- 3.3.1 Controller Panel LEDs 36
- Mode JW1 JW2 36
- 3.3.3 Power Supply 38
- 3.4 Connecting the Inputs 39
- 8 Input Terminals 40
- 3.4.2 Request to Exit 41
- 3.4.3 Door sense 41
- 3.4.4 General purpose input 41
- 3.4.5 Active state 41
- 3.4.6 Supervision requirement 41
- Active when short 42
- 47 K ohms 42
- Active when open 42
- 22 K ohms 43
- 3.5.2 Active state 44
- 3.5.3 Outputs 1 to 6 44
- OUTPUT 7 OUTPUT 8 45
- Door Strike 45
- 3.6.2 Card Reader Connection 46
- 3.7 Setting DIP Switches SW2 47
- Configurator software 48
- 3.8 Setting Jumpers 51
- 3.9 Turning on the Controller 52
- 3.10 Updating Firmware 52
- 3.11 Beginning Configuration 53
- Limited Warranty 55
- International Warranty 55
- Conditions to Void Warranty 55
- Warranty Procedure 56
- Disclaimer of Warranties 56
- Out of Warranty Repairs 57
- Special Notices 58
- Type of Service 59
- Telephone Company Procedures 59
- Changes to Telephone Service 60
- Ringer Equivalence Number 60
- If Problems Arise 60
- Product Identifier 60
- Telephone Connection 61
- Equipment Failure 61
- Use on Party Lines 61
- Use With Alarm Auto Dialers 61
- Hearing Aid Compatibility 61
Related products and manuals for Door intercom systems Mircom TX3 Series
(226 pages)© 2020, manymanuals.com. All rights reserved. | 0.497 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals