Mircom TX3 Series User's Guide download pdf (Page 25)

Configurable Features

Version 2.2 TX3-CX Card Access System Installation and Operation Manual 25 (61)

Auto relock. Enabling this option locks the door when the door closes before the

door open timer or extended door timer expires. Disabling this option locks the

door, but only after the expiration of door open timer or extended door open

timer.

Deduct usage count. For cards designated as “temporary” (that is, the usage

counter option is enabled and set to a value below 255), this option decreases the

usage counter by one every time this card is used at the access point. When the

usage counter reaches zero, the card deactivates.

Disable forced entry alarm. Disabling the forced entry alarm will not activate

the forced entry alarm even if the door is opened without permission. Instead an

access granted sequence is started. This is usually used on access points where

there is no request to exit (RTE) device.

Ignore card facility code. This option is enabled by default meaning that only

card number will be processed. If this option is unchecked, then for every card,

card number and facility code will be processed to grant access.

PC decision required. When enabled granting access is transferred to the PC

from the controller. For this option to work the PC needs to be on all the time with

an attendant. Use this option when the building has a security desk or a concierge.

First person In. Configuring the access point for the lock/unlock schedule,

causes the door to remain locked at the start of the unlock schedule, until the first

valid card with this privilege is presented to the card reader. The door continues

to remain unlocked for the remainder of the unlock schedule.

RTE bypass DC. When enabled, requests to exit (RTE) bypass the door contact

(DC) and do not unlock the door. This is typically used where there is a

mechanical egress device installed on the door.

High security. When enabled only access cards with the high security privilege

are able to open the door.

Report request to exit. This option logs and monitors events and system status.

When enabled any requests to exit are logged and reported to the configurator.

Since the person exiting is not known, only the time and date and the request itself

is logged and reported.

Report door not opened. When enabled this option logs and reports events

when access is granted but the door remains closed.

Report unknown format. When enabled this option logs and reports access

attempts with a card with an unknown format.

Facility code mode. Enabling this mode grants access to cards based on only

their facility code. This allows nonprogrammed cards to have complete building

access. Use only when necessary.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 60 61

No comments

Mircom TX3 Series User's Guide Page 25