Mircom TX3 Series User's Guide Page 26
- Page / 61
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
26 (61) TX3-CX Card Access System Installation and Operation Manual Version 2.2
LT-980 Copyright 2015
Configurable Features
Inhibit ID. When enabled the card code is not sent to the PC. This feature is used
for logging and reporting purposes.
Timed Anti-passback. When enabled access is not permitted at the same access
point for a specific amount of time specified by the anti-passback timer.
2.3.12 Card options
Access cards are configured for the following features:
Usage counter. The usage counter is used for temporary cards. The usage
counter can be given any value from 1 to 255. Using 255 means there is no
restriction on usage. If any other value is used it means the card is only usable for
that number of times.
Status. The status of the access card is marked as:
•Active
• Inactive
Inactive cards are not granted access. Active cards are granted access provided
all the other conditions like schedule and privilege are met.
Access level. Select the access level for the card. Access levels are configurable
on the basis of privilege. Up to 128 access levels can be defined for the system.
PIN. The PIN code is a 1 to 4 digit numerical value used during the card + PIN
schedule. 0 is not accepted.
Ignore anti-passback. When this option is enabled the card holder is not
restricted by the timed anti-passback mode.
Lock/Unlock privilege. When this option is enabled the user has the privilege of
unlocking the door by presenting the card to the reader twice in succession.
High security privilege. When this option enabled only access cards with this
privilege are able to open the door.
Extended unlock time. When this option is enabled the door opens for the
extended unlock time (see section 2.4.3, Extended unlock time). This option is
normally given to seniors and persons with disabilities.
Handicap. When this option is enabled the output designated as accessible is
activated along with the main door.
First person in. This option works in conjunction with scheduled unlock modes
only. If the First person in setting is enabled, only a card with the First person in
privilege can start the unlock mode.
- TX3 Series 1
- Copyright 2015 Mircom Inc 2
- All rights reserved 2
- Table of Contents 3
- List of Figures 6
- 1.2 Applications 8
- 1.3 Configurable Features 9
- 1.5 Network Setup 10
- LT-980 Copyright 2015 11
- 1.6 About This Manual 13
- 1.7 Contact Us 14
- 1.7.5 Technical Support 15
- 1.7.1 General Inquiries 15
- 1.7.2 Customer Service 15
- 1.7.3 Website 15
- 1.7.4 Email 15
- Configurable Features 17
- 2.1 Inputs 18
- 2.2 Correlation 19
- 2.3 Access Criteria 20
- 2.3.1 Lock / Unlock 21
- 2.3.2 High security 22
- 2.3.3 PC decision required 22
- 2.3.4 Facility code mode 22
- 2.3.5 Card + PIN 23
- 2.3.6 Anti-passback 23
- 2.3.7 Temporary card 23
- 2.3.8 Interlock 23
- 2.3.9 Access level 23
- 2.3.10 Controller options 24
- 2.3.11 Access point options 24
- 2.3.12 Card options 26
- 2.4 Timers 27
- 2.5 Schedules 28
- 2.6 Holidays 29
- 2.7 System Status 29
- • door held open alarm 30
- Installation and Setup 31
- 3.2.1 Optional Components 32
- 3.2.5 Installing the modem 33
- Installation and Setup 34
- SW1ONOFF 35
- Interface connection 35
- MD-921 IP Module 35
- Board location 35
- 3.3.1 Controller Panel LEDs 36
- Mode JW1 JW2 36
- 3.3.3 Power Supply 38
- 3.4 Connecting the Inputs 39
- 8 Input Terminals 40
- 3.4.2 Request to Exit 41
- 3.4.3 Door sense 41
- 3.4.4 General purpose input 41
- 3.4.5 Active state 41
- 3.4.6 Supervision requirement 41
- Active when short 42
- 47 K ohms 42
- Active when open 42
- 22 K ohms 43
- 3.5.2 Active state 44
- 3.5.3 Outputs 1 to 6 44
- OUTPUT 7 OUTPUT 8 45
- Door Strike 45
- 3.6.2 Card Reader Connection 46
- 3.7 Setting DIP Switches SW2 47
- Configurator software 48
- 3.8 Setting Jumpers 51
- 3.9 Turning on the Controller 52
- 3.10 Updating Firmware 52
- 3.11 Beginning Configuration 53
- Limited Warranty 55
- International Warranty 55
- Conditions to Void Warranty 55
- Warranty Procedure 56
- Disclaimer of Warranties 56
- Out of Warranty Repairs 57
- Special Notices 58
- Type of Service 59
- Telephone Company Procedures 59
- Changes to Telephone Service 60
- Ringer Equivalence Number 60
- If Problems Arise 60
- Product Identifier 60
- Telephone Connection 61
- Equipment Failure 61
- Use on Party Lines 61
- Use With Alarm Auto Dialers 61
- Hearing Aid Compatibility 61
Related products and manuals for Door intercom systems Mircom TX3 Series
(226 pages)© 2020, manymanuals.com. All rights reserved. | 0.886 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals