Mircom FA-300 Series Specifications download pdf (Page 8)

Functional Setup

DIP Switches

There are two DIP switches to be set. SW30 is found at the bottom right corner of the board and is used to select

the annunciator address. Valid addresses are 1 to 6 inclusive for FA-300 Series, 1 to 7 for FX-350/351. Set address

as follows:

RAM-300LCD Address DIP Switch Setup

DIP switch SW31 is found at the bottom left hand corner and is used to select a number of features. DIP switch

SW31 is set as follows:

Address SW30-1 SW30-2 SW30-3

1ONOFFOFF

2OFFONOFF

3ONONOFF

4OFFOFFON

5ONOFFON

6 OFF ON ON

7 (FX-350/351) ON ON ON

Note: SW30-4 DIP switch is not used.

Note: For the FX-350/351 Series Fire Alarm Panels, if the number of annunciators programmed is 5, then

the first five addresses (1 to 5 inclusive) must be assigned to the RAM-300LCD annunciators.

DIP Switch SW31 Position Function

1 ON Disable System Reset Button

1 OFF Enable System Reset Button

2 ON Disable Signal Silence Button

2 OFF Enable Signal Silence Button

3 ON Disable Fire Drill Button

3 OFF Enable Fire Drill Button

4 ON Disable Lamp Test Button

4 OFF Enable Lamp Test Button

5 ON Disable Buzzer Silence Button

5 OFF Enable Buzzer Silence Button

6 NOT USED

7 ON 16 bit checksum (for FX-350/351 panels)

7 OFF 8 bit checksum (for FA-300 Series panels)

8 NOT USED

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

No comments

Mircom FA-300 Series Specifications Page 8