Mircom FA-300 Series Specifications Page 1

. . . . . ... .. .. . . . . . .. . .. . . . . . . ... . .. . . .. . .. . ... ... . .. ...! . "... ... . .. ##.© Mircom 2005Printed in

Wiring6The RAM-300LCD is wired as shown below. Additional RAM-300LCDs are wired in the same manner, make sure ONLY the last RAM-300LCD has the 120 oh

RAM-300LCD Installation and Operation Manual7Specifications & FeaturesEnclosureEnclosure may be mounted on a 4” square electrical box or on a wal

Operating Instructions8Operating InstructionsNormal: All indicators are normally OFF except for the green A.C. ON light which illuminates steadily.Al

RAM-300LCD Installation and Operation Manual9Warranty & Warning InformationWarning Please Read Carefully Note to End Users: This equipment is sub

Warranty & Warning Information10of closed doors; and, smoke and heat detectors may not detect smoke or heat from fires on another level of the res

RAM-300LCD Installation and Operation Manual11Limited Warranty Mircom Technologies Ltd. warrants the original purchaser that for a period of two year

Warranty & Warning Information12Out of Warranty Repairs Mircom Technologies Ltd. will at its option repair or replace out-of-warranty products whi

Notes

Canada25 Interchange WayVaughan, ON L4K 5W3Tel: 905-660-4655 Fax: 905-660-4113© Mircom 2007Printed in CanadaSubject to change without prior noticewww.

RAM-300LCD Installation and Operation ManualiContentsIntroduction ...

RAM-300LCD Installation and Operation Manual1IntroductionThe RAM-300LCD is a remote annunciator used for the FA-300 Series and FX-350/351 Series Fire

Mechanical Installation2Mechanical InstallationTo mount the RAM-300LCD open the front door, remove the dead front plate and mount the backbox to the w

RAM-300LCD Installation and Operation Manual3Functional SetupJumpersPotentiometerVR1 is a potentiometer used for LCD contrast adjustment and is locat

Functional Setup4DIP SwitchesThere are two DIP switches to be set. SW30 is found at the bottom right corner of the board and is used to select the an

RAM-300LCD Installation and Operation Manual5WiringTo wire the RAM-300LCD, you must first remove the dead front plate. Wire from the last RAM-300LCD